新闻详情

气体增压泵清洗时需要注意的事项

1、不能用煤油、酒精或是其它腐蚀性液体,以防液压器元件、油箱等部件受到腐蚀,影响液压器的正常使用。

1, can not use kerosene, alcohol or other corrosive liquids, to prevent the hydraulic device, fuel tank and other components from corrosion, affecting the normal use of the hydraulic device.

2、清洗气体增压系统时,液压泵运转和清洗介质加热应同时进行。因为,清洗油液的温度为五十摄氏度到八十摄氏度时,系统内的橡胶渣时很容易被除掉的。

2, cleaning gas pressurization system, hydraulic pump operation and cleaning medium heating should be carried out at the same time. Because, the cleaning oil temperature of fifty degrees Celsius to eighty degrees Celsius, rubber residue within the system is easy to be removed.

3、液压泵工作的时候进行间歇性的运转可以提高清洗效果。

3, the hydraulic pump when the work of intermittent operation can improve the cleaning effect.

4、我们应该在气体增压系统的清洗油路的回路上安装过滤器,这样可以过滤掉系统内大部分的杂质。

4, we should install the filter in the cleaning oil gas pressurization system circuits, it can filter out impurities in the system.

5、清洗液压泵的时间一般在四十八小时到六十小时之间,这是由系统的复杂程度和污染程度等因素决定的。

5, cleaning hydraulic pump time in forty-eight hours to sixty hours in between, which is determined by the complexity of system and the degree of pollution etc..

6、清洗结束时,不要立即使液压泵停止运转,应该使其持续运转直到液压泵气温恢复正常,这样可以防止外界湿气使内部器件生锈

6, at the end of cleaning, do not immediately make the hydraulic pump to stop running, should make it run until the hydraulic pump temperature returned to normal, it can prevent outside moisture so that the internal device rust.

7、清洗完气体增压系统后要及时把回路内的清洗油去除干净。

7, washing the gas pressurization system in time after the cleaning of oil within the loop removal.

气体增压泵

BACK
map
联系我们:
江苏省恒光屏蔽泵有限公司
电话:
0523-527638
邮箱:
rhjfpxixy@healthy-superstore.com

版权所有:江苏省恒光屏蔽泵有限公司, All rights reserved

地址:江苏省泰州市  电话:0523-527638  邮箱: rhjfpxixy@healthy-superstore.com